Installing Palm v Battery
A brief guide on how to replace the battery for your Palm V
Tools (continued)
- View:
- Single page
EditStep 2
- Heat the left and top edges with hairdryer for one minute.
- Move hairdryer back and forth to evenly heat up surface.
- Caution: directly heating the screen can melt or distort the screen.
EditStep 3
- Use tweezers to hold Palm right side down on it's side.
- Use a plastic opening tool to pry open front and back casing.
- If you are unable to open you may need to heat with hairdryer for longer.
- Be sure not to touch case directly with fingers, it will be hot!
EditStep 4
- Leave plastic opening tools in between front and back casing.
- Rotate Palm and repeat steps 2 and 3 for right and back edges.
EditStep 5
- Now pry open front and back casing with plastic opening tools.
- Separate front and back casing completely.
- Power button will fall off once front and back casing have been removed. Be sure not to lose it.
EditStep 6 — Screen
- In order to seperate the screen from the motherboard you must disconnect the ribbon attached to the screen.
- To do this, using tweezers, flip up the cable clamp that is connecting the ribbon to the screen.
- Once the clamp is up you can use the tweezers to gently detach the ribbon.
EditStep 7
- Now you must flip up the adjacent clamp as well, using tweezers like before.
- After the clamp is flipped you can gently remove the second ribbon with tweezers.
EditStep 8
- Before removing the screen you must detach one more wire, the battery connector.
- Using the tweezers, squeeze the connector attached to the wire and genlty pull.
- Do not pull from the wire.
Page 1 of 2
Nenhum comentário:
Postar um comentário